Powertrax 9201202900 User Manual
Page 16
14
32.
Check the gap between driv-
ers using check block. The nar-
row side of the block should fit
between drivers, but the wider
side should not fit.
Go
No-Go
Saddle
springs
Pinion
shaft
opening
34.
Keeping both drivers fully
engaged, rotate both wheels back
1/4 turn to expose pinion shaft
opening. Make sure saddle springs
are all fully seated and the pinion
shaft opening in the thrust block is
aligned with the pinion shaft open-
ing in the drivers.
33.
Push passenger side axle shaft
inward through coupler as far as it
will go. The axle shaft should push
the thrust block against the opposite
axle shaft. Bolt axle shaft back to
housing.
If gap is incorrect, STOP and call
Powertrax Technical Support at
864-843-9275.
There may be a
problem with your differential case.