Bunn CWTF - Manual (Page 4)

Page 4
USER NOTICES
Carefully read and follow all notices in this manual and on the equipment. All labels on the equipment should be kept in
good condition. Replace any unreadable or damaged labels.
#12364.0000
WARNING !
Fill water tank before turning - on -
thermostat or connecting appliance
to power source.
Use only on a properly protected
circuit capable of the rated load.
Electrically ground the chassis.
Follow national/local electrical codes.
Do not use near combustibles.
FAILURE TO COMPLY RISKS EQUIPMENT
DAMAGE, FIRE, OR SHOCK HAZARD
READ THE ENTIRE OPERATING MANUAL
BEFORE BUYING OR USING THIS PRODUCT
THIS APPLIANCE IS HEATED WHENEVER
CONNECTED TO A POWER SOURCE
00831.0000F 3/98 ©1998 BUNN-O-MATIC CORPORATION
#00658.0000
#00656.0001
#00831.0000
As directed in the International Plumbing Code of the
International Code Council and the Food Code
Manual of the Food and Drug Administration (FDA),
this equipment must be installed with adequate
backflow prevention to comply with federal, state
and local codes. For models installed outside the
U.S.A., you must comply with the applicable Plumb-
ing /Sanitation Code for your area.
To reduce the risk of electric shock,
do not remove or open cover.
No user-serviceable parts inside.
Authorized service personnel only.
Disconnect power before servicing.
#37881.0000
#34955.0000
APS MODELS
WA R M E R S A N D S U R FAC E S A R E H OT CAUTION
#02765.0000
#34955.0003
THREE WARMER BREWERS
120V
120/208-240V
#34056.0000
VOLTAGE SELECTOR SWITCH
Optional Field Wiring
120/208-240 V, 11.4-13.1 A, 2340-3100 W
1PH, 3-Wire + GND , 60HZ
34955.0000D
Optional Field Wiring
120/208-240 V, 13.9-15.6 A, 2640-3400 W
1PH, 3-Wire + GND, 60HZ
34955.0003D
#34955.0002
TWO WARMER BREWERS
Optional Field Wiring
120/208-240 V, 13.0-14.8 A, 2540-3300 W
1PH, 3-Wire + GND, 60HZ
34955.0002D
#34955.0001
ONE WARMER MODELS
Optional Field Wiring
120/208-240 V, 12.25-13.9 A, 2440-3200 W
1PH, 3-Wire + GND, 60HZ
34955.0001D
#03409.0002
#03408.0002
41721 080310