Phoenix Audio Quattro3 USB and Smart Interface MT303 - Manual (Page 3)

CONNECTING YOUR Q3
CONNECT TO A COMPUTER
This connection is for any session using your computer, such as Voice Over IP applications
(Skype, Vidyo, etc.)
1 Using the USB cable provided, plug the mini USB side of the cable into
the Q3 (located on the connector panel below the unit).
2
Plug the USB end of the cable into any USB port on your computer.
Your Quattro3 is ready to use.
No additional drivers or steps are needed. However we do recommend downloading and using
our “Phoenix Audio Setup Utility” for optimal audio control and performance. This utility can
be found on our website:
www.phnxaudio.com
CONNECT TO A SMART DEVICE
This connection is for any session using a smart phone, tablet, or any device that requires an
analog audio signal (Video Codec Systems, recorders, etc.).
1 Using the provided audio cable or any custom made cable, plug the 2.5mm 3-pin connector
side into the Q3’s “Audio Out” jack (located on the connector panel below the unit).
2 Plug the other end of the provided cable (3.5mm 4pin connector) into your smart phone
or table’s headphone/headset jack.
3 If applicable, make sure to select the use of the “headset” on your device. Your Quattro3
is ready to use.
quatte03-301-8-31
WEIGHT:
A4
SHEET 1 OF 1 SCALE:1:1
DWG NO.
TITLE:
REVISION DO NOT SCALE DRAWING
MATERIAL:
DATE SIGNATURE NAME
DEBUR AND
BREAK SHARP
EDGES FINISH: UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
Q.A
MFG
APPV'D
CHK'D
DRAWN
2.5mm Analog
Audio Out
Interface Module
3.5mm External
Speaker/Microphone Mini USB
Connector Panel
DC Power
Connector
Daisy Chain Connectors
Down (right)
Up (left)