Phoenix Audio DRS-Q4 Mk2 - Stereo Class A Microphone Pre-Amplifier/DI/EQ - Manual (Page 2)

DRS-Q4 mk2 Specifications
1U rack space unit: With 240V/110V mains voltage input selector switch
Class A (DSOP-2) Output specs. Frequency response: 20Hz to 20kHz +- 0.5dB,
Maximum Output Level: +26dBu @ 1kHz
Noise: -90dB @ 20Hz to 20kHz.
Output connections: XLR and TSR 1/4" Jack on rear
Phoenix Audio’s unique Class A, transformer-less, True balanced Mic input stage.
Microphone/Line input: XLR on Rear Panel
DI inputs: _” TSR Jack on Front Panel
Individual Earth Lift: Push-button Switches
Gain Range (Mic input): -30 to -70 in 5dB steps With 10dB more available on the fader.
Gain reduction: -30dB pad push-button Mic/Line switch (Mic input)
High Input Impedance DI: Mono 1/4" Jack on front panel (no FETs)
Gain Meter: LED Metering. (Green = 0dB, Yellow = +8dB, corresponding to “4” and “6”
on a PPM Meter).
Phantom Power: Switchable phantom on Push-button Switch
High Pass Filter: Roll-off starts at 120Hz @ 12dB per Octave.
Phase Reverse: on Push-button Switch
Frequency Response Mic Input Stage: -0.4dB @ 40Hz, -0.3dB @ 25kHz
Frequency Response: DI Input Stage: -0.3dB @ 40Hz, - 0.5dB @ 25kHz
Typical Headroom: +26dB on Mic-Pre stage
Gyratory-based EQ Frequency Centres: (4 Bands) High - 15K, 10K, Hi Mid - 6K, 3K,
1K6, Low Mid – 800Hz, 400Hz, 200Hz, Low - 130Hz, 80Hz, 40Hz
EQ Cut/Boost Levels: 16dB Cut/Boost Per Band with fully detented pots in 21 positions
DI Stage gain: Maximum of 30dB