BridgeWave SLE100 - Manual (Page 37)

TM
SLE100 Installation Manual
32 590-00532, rev A
Low link quality
voltage
Wireless link
established but no data
transfer over the link
Antennas are not aligned for
maximum RSL Use the Visual Alignment Tool
and voltmeter to verify antenna
alignment.
Auto-calibration not
completed Force an Auto-calibration from
the ‘Maintenance’ page.
Interference Check for possible interference
by turning off the radio at the
other end of the link or muting
its transmitter and verify the
RSL voltage on the local site
drops below 0.2V.