Oxford Garden Dartmoor Bar Stool - Manual (Page 2)

Assembly Instructions
page 2
Dartmoor Stool
Step 1
On a clean flat surface, lay the right front leg 2 (front leg has
two lower mortise holes), and the right rear leg 4 (rear leg has
one lower mortise hole) on their sides mortise holes facing up.
Step 6
Enjoy your new bar stool!
Step 2
Line up the seat 1 , and insert into the legs.
Step 4
Place the left front leg 3 and the left rear leg 5 onto the
parts already assembled.
Step 3
Line up the foot rest 6 , and insert into the legs.
Step 5
With a hammer, drive 12 total dowels A into the predrilled holes on
the inside of the front and rear of the legs as shown. Insert the tapered
end of the dowels first. NOTE: The dowels should be easily driven in
flush. If there is strong resistance, do not force the dowel. Sand to
smooth off areas around the dowel pins.
A
3
5
* Apply glue in this step. * Apply glue in this step.
* Apply glue in this step. * Apply glue in this step.
* See page 1 for gluing instructions.
4
6
2
3
5
1