Oxford Garden Siena Reclining Armchair - Manual (Page 2)

Assembly Instructions
page 2
Siena Reclining Armchair
Step 1
First prepare the seat assembly. Insert the steel rod A through the pre-
drilled holes of the seat back 1 and seat 2 . Place the nylon washer B
on the rod followed by the polyethylene blocks C as shown.
Step 2
On a clean flat surface, lay right leg assembly 3 on its side mortise holes
facing up. Place front seat rail 5 , and rear seat rail 6 into mortise of
right leg assembly. A steel pin indicates the rear of the chair. Next, slide
the 2mm washer onto the steel pin at the rear of the chair.
Step 4
Place left leg assembly 4 onto those parts already assembled. Again,
slide the 2mm washer onto the steel pin, align the polyethylene block
and the steel pin to fit into the mortise of the rail on the left leg
assembly and the seat back.
Step 3
Line up the completed seat assembly so the polyethylene block fits into
the long mortise in the rail on the right leg assembly and the steel pin of
the leg assembly fits into the mortise located on the seat back.
Step 5
With a hammer, drive 8 total dowels D into the predrilled holes found
on the front and rear of the leg assemblies. Insert the tapered end of
the dowels first. NOTE: The dowels should be easily driven in flush. If
there is strong resistance, do not force the dowel. Sand to smooth off
areas around the dowel pins. Your chair is now ready to enjoy!
2
A
B
1
C
E
5
6
3
4
E