Oxford Garden 2 Backless Bench - Manual (Page 2)

Step 1
On a clean flat surface, lay right leg assembly on its side
mortise holes facing up. Locate the small label on the bottom of the
seat that reads “front”. With the front of the seat toward the front of
the bench, line up and insert the front seat rail and seat into
the right leg assembly. Insert the large rounded pegs at the front
of the seat into the front seat rail.
Step 3
Insert the tenon of the bottom rail into the mortise
of the right arm assembly.
Place back seat rail into position, holes facing inward. Insert the
large rounded pegs at the back of the seat into the back seat rail. Insert the left leg assembly into the rest of the assembled parts.
Secure the bottom rail by inserting a wood screw through the
under part of each leg as shown in figure 1 below.
Step 5
Step 6
Using a phillips head screwdriver, screw the remaining six
wood screws into the predrilled holes on the underside
of the seat to attach the seat back, front rail and leg
assemblies as shown.
B
Assembly Instructions
page 2
Backless Bench - 2'
Step 4 Step 2
With a hammer, drive 8 dowels into the predrilled holes as shown.
NOTE: Insert the tapered end of the dowels first. The dowels should
be easily driven in flush. If there is strong resistance, do not force the
dowel. Sand to smooth off areas around the dowel pins. A 6
2 4
A
6
B
4
Figure 1
B
B
B
B
3
3
1
1
5
5
2
B
A
A
A
B
B B