Orbit Baby Generation-one Toddler Car Seat - Manual (Page 25)

Rear
-Facing Installation
48
48
Rear
-Facing Installation
49
49
14. CHECK that the Toddler Car Seat is
level by looking at the Level Indicator on
the Brace (Photo G). If the seat is not
level, remove the seat and re-install it by
repeating Steps 2 to 13.
15. If the Toddler Car Seat cannot be
secured tightly and level, try any of the
following:
a) Try installing the Toddler Car Seat in
a different seating position.
b) Remove the seat. Position a rolled
towel underneath it (Photo H), and
repeat Steps 2 to 13.
c) Seek assistance from one of the
resources in the “Need Help Securing
Your Toddler Car Seat and Base?”
section (page 27).
NOTE: The Toddler Car Seat must be
level to prevent ejection of your child.
Do not use until properly installed.
1. Attach the Braces in a Rear-Facing
position: see pages 41-43.
2. Position the carseat Rear-Facing on the
vehicle seat. The child seat should face
the rear of the vehicle. The FRONT OF
VEHICLE arrow on the Braces should
point to the front of the vehicle (Photo I).
3. Open the Upholstery Lower Panel
marked by the Blue Dot (Photo J).
4. Fully open both arms of the blue Belt
Lock-Off Clamp that is on the side
closest to the center of your vehicle.
(Photo K). Only one clamp is needed for
a secure installation.
5. Position both the shoulder and lap
portions of the belt through the Rear-
Facing Belt path openings in the shell
(Photo L) and the open Blue Lock-Off
Clamp and buckle the seat belt buckle.
Installation with Braces,
Shoulder-Lap Seat Belts
(without Orbit Base)
Installation with Braces & LATCH System
(without Orbit Base) cont’d
G
H
I
J
K
L