Orbit Baby Generation-one Stroller - Manual (Page 11)

Get Rolling
20
20
Get Rolling
21
21
Installing and Removing the
Rear Wheels
To install the Rear Wheels:
1. Press the button in the center of
the Rear Wheel (Photo J) and, at
the same time, slide the Wheel Axle
into the rear strut (Photo K). It will
be a tight fi t between the wheel
axle and rear strut. It may help to
support the rear strut on a fi rm
surface during assembly.
2. Release the center button and push
the Rear Wheel into place until you
hear and feel a
CLICK.
3. CHECK that the Rear Wheel is fully
seated by trying to pull it back out.
4. CHECK tire pressure of the rear
tires before use. The maximum
air pressure of the tires should be
15 psi. See the “Using Your Orbit
Pump” section on page 22.
To remove the Front Wheels:
1. Slip the Front Fork Removal Tool
provided in your Maintenance Kit
over the plastic tabs at the top of
the Front Wheel (Photo I).
2. Pull the Front Wheel out from under
the Front Cross Brace.
3. Repeat with the other Front Wheel.
Installing and Removing the Front
Wheels cont’d
K
J I