NTi Audio FLEXUS FX100 - Manual (Page 3)

www.nti-audio.com Page 3 / 4
staRt Of OpeRatiOn
Unpack items. 1.
Install software. 2.
Insert FLEXUS CD into the CD drive of your PC. •
Open CD drive folder and double-click on setup.exe. •
Follow installation instructions. •
Connect FLEXUS to mains power. 3.
Connect FLEXUS and PC with USB cable, using the 4.
USB-B connector.
Launch FX-Control.
5.
FX-Control will start with a default measurement project 6.
For further information on how to operate FX-Control, please use the 7.
online help via the “F1” key.
HOW tO ...
Operate the fX 100 front panel
The FX100 can be operated with the Push&Turn
wheel on the front panel. It allows navigating
through a menu system.
By turning the wheel, the highlighted active •
item can be changed.
By pressing on a active item, the functional-
•
ity gets active.
perform a firmware upgrade
If there is a new firmware available, FX-Control will
notify you upon startup.
Confirm and download the *fxu file to the •
root folder of an USB memory stick.
Plug the USB memory stick into one of the
•
USB Type-A connectors of your FLEXUS
unit.
Select the FLEXUS menu
• SYSTEM → =VER
→ FW-UPDATE
Select the stored fxu file from the list. •
The firmware upgrade will proceed automatically. This may take up to a few minutes. Do •
not switch off the unit during the firmware upgrade process.