Bunn Titan Single 40885.0000E - Manual (Page 6)

Page 6
ENABLE
ON / OFF
BREW
SMALL
LARGE
BREW
A. MAIN ON/OFF SWITCH
This switch, located under the brewer in front of the right rear leg, turns power on and off to all components
in the brewer.
B. ON/OFF SWITCH (ENABLE BREW)
Pressing the "ON/OFF" switch will alternately turn the brew components on and off. Pressing this switch during
the brew cycle will interrupt the brew cycle, stopping the flow of water. Pressing this switch during programming
of the brewer will exit the setup and return to the main screen.
C. PROGRAMMING (left)
This hidden switch can be used to scroll backwards through the function list while in programming mode.
D. BREW
When the ON/OFF (Enable Brew) switch is ON and the main screen is visible, momentarily pressing and
releasing this switch will begin a brew cycle on the selected side.
E. PROGRAMMING (right)
Pressing and holding this switch allows entry into the programming menus. Pressing and releasing the switch
steps through each function screen while in the programming mode.
F. BATCH SELECTOR SWITCHES
Pressing the switch corresponding to the Half or Full batch selects the amount of product to be brewed.
Pressing a different switch after a brew cycle has been initiated does not change the brew batch in progress.
Light indicates the selected batch to brew. Also used in programming to adjust settings on both batch sizes.
G. FUNCTION SCREEN
This is the display which shows the various functions of the brewer and allows the programming to be ac-
complished.
H. FUNCTION SCREEN SWITCHES
These are hidden switches which are used to program the brewer when in the programming mode.
OPERATING CONTROLS
E C
D
READY TO BREW
WATER TEMP: 200°
B G
F
H
P3894
40885 080108