B&K AVR317 - Manual (Page 46)

42
Presets
Usually these settings may be left set to the factory defaults. However, your receiver allows ‘fine tuning’ of how
presets operate. Make sure you are in the SETUP MENUS and your remote is in B&K mode.
From Remote From Front Panel Action
1 À(PAUSE) or §(STOP) (UP) or (DOWN) move to Presets
2 SEL or ENTER (ENTER) activate SETUP PRESETS
Use volume with presets - Recalling a preset normally recalls the entire system settings that were present when
the preset was saved. However, you may wish to recall presets with the current volume setting, rather than the
volume setting when the preset was saved. If so, then set Volume in Presets to No.
From Remote From Front Panel Action
1 ¶ (REW) or • (FF) VOLUME KNOB select Yes or No
MAIN MENU
1 Zone 1 Operation
2 Zone 2 Operation
3 Zone 1 Favorite Presets
4 Zone 2 Favorite Presets
5 System Setup
6 Memory Backup/Restore
next item SEL select
MENU exit menu system
5 System Setup
SETUP SYSTEM
1 Speakers
2 Displays
3 Inputs
4 Presets
5 Music Modes
6 Advanced
next item SEL select
MENU main menu
4 Presets
SETUP PRESETS SYSTEM SETUP
SETUP PRESETS
1 Volume In Presets Yes
When recalling a preset
volume level changes to
preset level
2 Preset Names Auto
When saving a preset
system generates a name
next item adjust
MENU setup system
PRESET VOL YES
1 Volume In Presets Yes
SETUP PRESETS
1 Volume In Presets No
When recalling a preset
volume level remains at
current level
2 Preset Names Auto
When saving a preset
system generates a name
next item adjust
MENU setup system
PRESET VOL NO
1 Volume In Presets No