Stow cutter 1 ce saw — initial start-up – Multiquip CD6CE13H18 User Manual

Page 21

STOW CUTTER 1 CE — OPERATION MANUAL — REV. #2 (12/20/07) — PAGE 21

STOW CUTTER 1 CE SAW — INITIAL START-UP

DO NOT attempt to operate the saw until
this manual has been read and
thoroughly understood. Engine operating
steps may vary. See included engine
manufacturer's operating manual.

Figure 16. Engine Fuel Valve Lever

2. Ensure the diamond blade has been mounted correctly and

that it is raised above the surface you are about to saw.

3. Place the

fuel valve lever

(Figure 16) to the "ON" position.

4. Place the

ENGINE ON/OFF switch

located on the ENGINE

(Figure 18) in the "ON" position. Place the

ENGINE ON/OFF

switch

located on the HANDLEBARS (Figure 14) in the

"ON" (center) position.

NEVER operate the saw in a confined area
or enclosed structure that does not provide
ample

free flow of air

INITIAL START-UP

Ensure the work area is clear of tool, debris, and unauthorized
people.

NOTE

The Engine Stop Switch located on the
handlebar (Figure 14) serves both as
an Emergency Engine Shut-Off and
as the primary ON/OFF switch. This
allows the operator to shutdown the
saw safely away from moving parts.

Figure 17. Engine ON/OFF Switch (On Engine)

NEVER place hands or feet inside the
belt guard or blade guard while the
engine is running. ALWAYS shut the
engine down before performing any kind
of maintenance service on the saw

Figure 14. Engine Stop Switches

WARNING

ALWAYS wear approved eye and hearing
protection while operating the saw.

1. Keep Wheel Clamp (Figure 15) applied

(lever DOWN) until completely ready
for cutting o peration.

Figure 15. Wheel Clamp

CAUTION

ENGINE STOP SWITCH

ENGINE STOP

SWITCH

(Emergency Stop

and Primary ON/OFF)

(Secondary ON/OFF)

CUTTER