Multiquip MP120E - Manual (Page 23)

MP1 SERIES MASONRY SAWS — OPERATION AND PARTS MANUAL — REV. #1 (03/29/10) — PAGE 23
PRE-SETUP (ELECTRIC)
5. Plug the free end of the extension cord into an AC power
receptacle. Whenever possible use a GFCI receptacle
(Figure 14) to reduce the risk of electrical shock.
Figure 14. GFCI Receptacle
6. The MP1 masonry saw is now ready for wet cutting . The pre-
setup procedures for electric models saws only is now
complete.
CAUTION CAUTION CAUTION CAUTION CAUTION
ALWAYS use a grounded (3-wire )
extension cord and MAKE CERTAIN that the
motor is connected to a properly grounded
electric circuit. If possible use a ground fault
circuit interrupter to protect the operator from
possible
electric shock .
DRY CUTTING (ELECTRIC SAWS ONLY)
1. Un-plug the water pump power cord from the outlet
receptacle on the electric motor conduit box.
NEVER dry cut with the pump connected
to a AC power source. Running the pump
dry will damage the pump. Always
disconnect the pump's power cord when
dry cutting.
CAUTION CAUTION CAUTION CAUTION CAUTION
2. The MP1 masonry saw is now ready for dry cutting . The pre-
setup procedures for electric models saws only is now
complete.