Multiquip WBH16EAWD - Manual (Page 18)

page 18 — WBH16eaWD poWer Buggy • operation anD parts manual — rev. #12 (09/09/13)
INSpECTION
BeFore starting
1. Read safety information at the beginning of manual.
2. Clean the machine, removing dirt and dust, particularly
the engine cooling air inlet, carburetor and air cleaner.
3. Check the air filter for dirt and dust. If air filter is dirty,
replace air filter with a new one.
4. Check carburetor for external dirt and dust. Clean with
dry compressed air.
5. Check fastening nuts and bolts for tightness.
engine oil CHeCK
1. To check the engine oil level, place the buggy on secure
level ground with the engine stopped.
2. Remove the filler cap/dipstick from the engine oil filler
hole (Figure 4) and wipe it clean.
Figure 4. Engine Oil Dipstick Removal
3. Insert and remove the dipstick without screwing it into
the filler neck. Check the oil level shown on the dipstick.
4. If the oil level is low (Figure 5), fill to the edge of the
oil filler hole with the recommended oil type (Table 3).
Maximum oil capacity is 3.52 pints.
Figure 5. Oil Level
gasoline CHeCK
1. Remove the gasoline cap (Figure 6) located on top
of fuel tank.
Figure 6. Fuel Tank
2. Visually inspect to see if fuel level is low. If fuel is low,
replenish with unleaded fuel.
3. When refueling, be sure to use a strainer for filtration.
Do not top-off fuel. Wipe up any spilled fuel.
tire pressure CHeCK
The wheels and tires of the WBH16EAWD are very
important in its effective operation.
1. Check the tires regularly to make certain the lugs nuts
are tight
2. Make sure tires are inflated to manufacturer's
suggested tire pressure. Do not operate the buggy
with bad or worn tires.
table 3. oil type
season temperature oil type
Summer 25°C or Higher SAE 10W-30
Spring/Fall 25°C~10°C SAE 10W-30/20
Winter 0°C or Lower SAE 10W-10
Danger
Motor fuels are highly flammable and can
be dangerous if mishandled. Do not
smoke while refueling. Do not attempt
to refuel the pump if the engine is hot or
running.