BenQ SP920 - Manual (Page 43)

43 Operation
Eng
lish Description of each menu
FUNCTION
(default setting/value)
DESCRIPTION
Wall Color
(Off)
Corrects the projected picture’s color when the projection surface is not
white. See
"Using Wall Color" on page 31 for details.
Aspect Ratio
(Auto)
There are four options to set the image's aspect ratio depending on your
input signal. See
"Selecting the aspect ratio" on page 30 for details.
Keystone
(0)
Corrects any keystoning of the image. See "Correcting keystone" on page
29 for details.
Position
(0)
Displays the position adjustment page. To move the projected image, use
the directional arrow keys. The values shown on the lower position of the
page change with every key press you made until they reach their
maximum or minimum.
Phase
(depends on the selected
input signal)
Adjusts the clock phase to reduce image distortion.
H. Size
(depends on the selected
input signal)
Adjusts the horizontal width of the image.
Digital Zoom
(100%)
Magnifies or reduces the projected image. See "Magnifying and searching
for details" on page 29 for details.
Picture Mode
(PC/DVI-D: Dynamic;
YPbPr/ S-Video/ Video/
HDMI/HDCP: Standard)
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See
"Selecting a picture
mode" on page 31 for details.
Reference Mode
Selects a picture mode that most suits your need for the image quality and
further fine-tune the image based on the selections listed on the same
page below. See
"Setting the User 1/User 2 mode" on page 32 for details.
Brightness
Adjusts the brightness of the image. See "Adjusting Brightness" on page 32
for details.
Contrast
Adjusts the degree of difference between dark and light in the image. See
"Adjusting Contrast" on page 32 for details.
Color
(0)
Adjusts the color saturation level -- the amount of each color in a video
image. See
"Adjusting Color" on page 32 for details.
Tint
(0)
Adjusts the red and green color tones of the image. See "Adjusting Tint"
on page 32 for details.
The function is only available when Video or S-Video with
NTSC system is selected.
Sharpness
(15)
Adjusts the image to make it look sharper or softer. See "Adjusting
Sharpness" on page 32 for details.
Brilliant Color
(On)
See "Adjusting Brilliant Color" on page 33 for details.
Color Temperature
(T3)
See "Selecting a color temperature" on page 33 for details.
3D Color
Management
See "3D Color Management" on page 33 for details.
Save Settings
Saves the settings made for User 1 or User 2 mode.
1. DISPLA
Y menu
2. PICTURE men
u