Multiquip WM700P - Manual (Page 6)

PAGE 6 — WHITEMAN WM-700S, 700P — PARTS & OPERATION MANUAL — REV. #7 (06/21/01)
RULES FOR SAFE OPERATION & SAFETY DECALS
The safety instruction decal is P/N 924801
SAFETY INSTRUCTIONS
1. Read owners manuals before operating.
2. Keep unauthorized and untrained people away from machine during operation.
3. Make sure all safety devices are in place before this machine is started.
4. Make sure engine is turned off and spark plug wire is disconnected before cleaning the
machine.
5. Keep hands and fingers away from moving objects.
6. Do not operate machine in an enclosed area. Proper ventilation is required.
7. Never leave machine unattended when operating.
8. Always stop engine and allow engine to cool before adding fuel or oil.
WHITEMAN CONCRETE PRODUCTS — A MULTIQUIP COMPANY — CARSON, CALIFORNIA
■ Do not operate or service this equipment
before reading the operating and maintenance
instructions manual or serious injury may
result.
■ Do not operate this equipment unless all
guards and safety devices are attached and
in place.
■ Stop the engine when leaving the
equipment.
■ Block the unit when leaving or when using
on a slope
■ Maintain this equipment in a safe operating
condition at all times.
■ Caution must be exercised while servicing
this equipment. Rotating and moving parts can
cause injury if contacted.
■ Stop the engine before servicing, adding
fuel and oil.
■ When towing, an adequate safety chain
must be fastened to the frame, refer to page 9.
■ Keep all inexperienced and unauthorized
people away from the equipment at all times.
■ Unauthorized equipment modifications will
void all warranties.
■ Check all fasteners periodically for tightness.
Also check towing tongue bolt, lock nut and
wheel lug nuts for wear.
■ Wear safety glasses at all times when
working around machinery.
■ Stop the engine and disconnect the spark
plug before allowing anybody’s hands in the
mixing drum.
■ Never pour or spray water over the engine
or electric motor.
■ Always stand clear of dump handle when
mixer is in operation. Any binding of material
between the mixer blades and drum will cause
drum and handle to quickly move in the
discharge position.
The safety instruction decals shown must be on all Whiteman Mixers
Caution Decal is:
P/N EM948423
CAUTION! CAUTION! CAUTION! CAUTION! CAUTION!
SHUT OFF ENGINE BEFORE SHUT OFF ENGINE BEFORE SHUT OFF ENGINE BEFORE SHUT OFF ENGINE BEFORE SHUT OFF ENGINE BEFORE
PUTTING HANDS IN MIXING DRUM PUTTING HANDS IN MIXING DRUM PUTTING HANDS IN MIXING DRUM PUTTING HANDS IN MIXING DRUM PUTTING HANDS IN MIXING DRUM