Wm-70 plaster/mortar mixer — start-up procedure, Caution – Multiquip WM70P User Manual

Page 25

WM-70 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (08/09/04) — PAGE 25

WM-70 PLASTER/MORTAR MIXER — START-UP PROCEDURE

Turn the engine switch (Figure 14) to the ON position.

The main

start/stop switch located on the engine cover

is (Figure 15) is used to start and stop the engine. Pull
this switch outward to start the engine.

Place the

belt slip lever (Figure 16) in the START/

STOP (disengaged) position.

Figure 16. Belt Slip Lever

(Start/Stop Position)

Pull the

starter grip (Figure 19) lightly until you feel

resistance, then pull briskly. Return the starter grip
gently.

Figure 19. Starter Grip

Figure 18. Drum Lock Pin (Right Position)

Figure 17. Drum Lock Pin (Side-View)

Make certain the

drum lock pin (Figures 17 and 18) is

placed to the RIGHT (when viewing the mixer from the
towpole end) of the drum stop block which is welded to
the front side of the drum. Also make sure lock pin is
fully engaged (locked). This will prevent the drum from
tipping.

CAUTION

Figure 15. Start/Stop Switch (gasoline engine)

Figure 14. Engine ON/OFF Switch

Preventing Drum Tipping

This manual is related to the following products:

WM70S