Mtr-35w — operation – Multiquip MTR35W User Manual

Page 13

MTR-35W— PARTS & OPERATION MANUAL — REV. #8 (06/26/01) — PAGE 13

MTR-35W — OPERATION

5. If engine fails to start, move the choke lever (Figure 4) to the

half open position to avoid flooding.

6. Repeat steps 1 thru 5.

If the engine does not start after repeated attempts,
check the spark plug for excess fuel. Clean and replace
the spark plug as needed.

Figure 5. Engine On/Off Switch

3. Close the choke lever (Figure 4) and move the throttle lever

(Figure 9) to the "Full Open" position. Turning the choke
lever 90 degrees clockwise closes the choke . In cold weather,
start the unit with choke fully closed. In warm weather or when
the engine is warm, the unit can be started with choke halfway
or completely open.

4. Grip the recoil starter (Figure 7) handle and pull it until you

feel a slight resistance. Then pull sharply and quickly. Return
the recoil starter handle to the starter position before releas-
ing.

Inspection

1 . Check all nuts, bolts fasteners for tightness. Retighten as

necessary.

2. Clean any dirt from the recoil starter and foot pedestal. Wipe

the entire unit clean before operating.

3. Replace any missing or damaged Safety Operation decals.

4. Adjust height of handle. Adjust handle by loosening nuts and

moving handle to suit operation. Retighten nuts.

Initial Start-up

When starting the MTR-35W Tamping Rammer perform the
following:

Open the fuel shut- off valve by moving the

fuel cock

lever

to the

open

position (Figure 4).

Figure 4. Fuel Cock and Choke Lever

Set the engine ON/OFF switch (Figure 5) to the "ON"
position (start).

3. Close the choke lever (Figure 4) and move the throttle lever

4. Move the throttle lever (Figure 6) between 1/4 to 1/2 from the

idle position.

Figure 7. Recoil Starter

Figure 7. Throttle Lever (1/4 to 1/2)