Barco MFGD 2320 User Manual
Mfgd 2320, User manual
Table of contents
Document Outline
- Contents
- Safety instructions
- 1. Overview
- 1.1. Introduction
- 1.2. Package contents
- 1.3. Controls and connectors
- Front
- Side
- Rear
- 2. Installation
- 2.1. Precautions
- 2.2. Before installing the display
- 2.3. Portrait or landscape position
- 2.4. Connecting the signals
- 2.5. Routing the signal cables
- 2.6. Using the USB hub
- 2.7. Tilt and swivel positioning
- 2.8. Starting up
- 3. Operation
- 3.1. Switching to stand-by position
- 3.2. Controlling the display
- About the on-screen menus
- Navigating through the menus
- Saving changes
- 3.3. Using the Autoset* functions
- When do you need to use the Autoset functions?
- Required test pattern
- To enter the Autoset menu:
- The Autoset menu contains the following items:
- 3.4. Controlling Video Contrast* and Video Brightness*
- To enter the menu:
- To change Video Contrast or Video Brightness manually:
- To select the calibrated position:
- Additional information
- 3.5. Setting the Luminance value
- 3.6. Making adjustments
- How to make the adjustments?
- Geometry adjustments
- Phase adjustments*
- 3.7. Selecting inputs
- To enter the Inputs menu:
- You can select the following input selection settings:
- 3.8. Settings
- To enter the Settings menu:
- The Settings menu contains the following items:
- 3.9. Scan Mode
- To enter the Scan Mode menu:
- The Scan Mode menu contains the following items:
- 3.10 Getting information
- To enter the Information menu:
- The General Information menu contains the following items:
- The Current Input Format information menu contains the following items:
- 4.1. About this chapter
- About the Advanced functions
- To log in as advanced user:
- 4.2. Advanced functions in the Adjustments menu
- Ambient Light Compensation
- Low Pass Filter*
- 4.3. Advanced functions in the Settings menu
- Lookup Table
- Input Mode
- OSD position
- 4.4. Advanced functions in the Scan Mode menu
- Autoscan
- Reset All
- 4.5 Advanced functions in the Information menu
- Service
- Firmware
- Runtimes
- Panel
- Cabinet
- Removing dust from the rear of the glass panel
- 6. Troubleshooting
- Windows does not show the desired display settings
- Pixel Faults
- 7. Technical specifications