Briggs & Stratton 5155 6 HP - Manual (Page 19)

OPERATING INSTRUCTIONS ANd PARTS ExPlOSIONS
CRT Models
Page 1 800-345-6007
PROBlEm REmEdY/ACTION
Belts squeal in neutral and/or reverse • Adjust forward belt guide:
- turn engine off and allow muffler to cool
- disconnect spark plug wire and secure from spark plug
- remove belt guard
- pull down on drive safety control levers
- manually bend forward belt guide so there is 1/16 inch
or less clearance between belt guide and belt
- replace belt guard and spark plug wire
Belts squeal in forward operation • Adjust tabs on the reverse belt guide
- turn engine off and allow muffler to cool
- disconnect spark plug wire and secure from spark plug
- release drive safety control levers to neutral position
- remove belt guard
- adjust tabs of reverse belt guide:
while drive safety control levers are released, bend
metal tabs on reverse belt guide to 1/64 inch or less
clearance from reverse belt
- replace belt guard and spark plug wire
Excessive heat build up in transmission/tine
area during tilling • Remove vegetation by following instructions in clean
Tine Axle Shaft of Normal care section.
FOLLOW ALL SAFETY INSTRUcTIONS
• check transmission fluid and fill if needed