MotorGuide 8M4000305 Gator Isolator Sleeve User Manual
Gator isolator sleeve upgrade

© 2006, MotorGuide
For Questions, Contact Consumer Affairs at #1-920-929-5040 90-8M4000186 Rev 3
www.MotorGuide.com
Gator Isolator Sleeve
Upgrade
8M4000305 – Gator Mount Isolator Sleeve Upgrade
8M4000306 – Gator Mount Isolator Sleeve Upgrade with Hardware
The Gator Flex 360 Mount Isolator Sleeve allows for adjustment, depending on use and personal preference. The
amount of shaft deflection can be changed with the installation of one or more, stiffer isolator halves.
Installation Instructions for the
Gator Isolator Sleeve Upgrade:
1. Place the mount in the deployed position.
2. Turn the bracket door knob to the left to open the bracket door (Figure 1).
Figure 1
3. Remove the two isolator sleeve pieces from the bracket and the bracket door (Figures 2 and 3).
Figure 2
Figure 3
4. Place anti seize grease on the threads of the door handle, the nut in the bracket and the knob washer located
between the handle knob and the door.
5. Install the isolator sleeves. To allow the isolators to align and properly seat, center one of the isolator sleeves in
the door and one in the mount bracket. Without the trolling motor installed, close the door and tighten. (Figure 4).
Open the door again to install your trolling motor.
Center Isolator in
mount Bracket
Figure 4
Center Isolator
Sleeve in mount