MitxPC VoomPC User Manual
Page 2
1.0 Introduction
Thank you for purchasing the VoomPC mini-ITX vehicle enclosure.
The VoomPC was designed to work with a wide variety of main boards such as the VIA
mini-ITX boards as well as low power Pentium-M OR Celeron-M. Please note that
powering full power P4 or AMD systems is not recommended due to excessive heat
dissipation. If using processors with TPD of 40 watts or more, please use two 40mm fans
for increased air circulation.
2.0 Required tools
In order to install the VoomPC in your vehicle you will need the following tools / materials:
-Phillips screwdriver and Wire cutter / stripper
-Few feet of wire (AWG 12-16), preferably color coded, used for power.
-Voltmeter (optional).
Figure 1.0, bottom mounting plate
VoomPC Installation Guide Page 2