MEElectronics Air-Fi Matrix2 AF62 - Manual (Page 5)

PAIRING WITH BLUETOOTH® DEVICES
*** It is only necessary to pair your Matrix once
with each device ***
Open the Bluetooth menu* on the device you wish to pair. Some devices
require you to select “search for devices” or “add new devices” in order to
create a Bluetooth pairing.
Make sure the Matrix is off and within 1 meter of your device. Initiate
pairing mode by pressing the Power button for 6 seconds, until you hear
“ready to pair, turn on Bluetooth, the pin code is 0000”. The red and blue
LEDs will flash in an alternating pattern while the Matrix is in pairing mode.
(Note: The Matrix will enter standby mode if not paired within 5 minutes.)
Wait until you see “Air-Fi Matrix 2” appear on your device
Select “Air-Fi Matrix 2” on your device and allow to pair. If your device
asks for a pin, enter “0000”. Once pairing is complete and a connection is
established, the blue LED on the Matrix will be on continuously
a)
b)
c)
d)
If pairing fails, please repeat steps a) through d) above
*Locating the Bluetooth menu:
iPhone, iPad, and iPod touch
On your device, go to Settings
Select Bluetooth (Bluetooth is under the General menu in iOS 5.1.1 and
older); if Bluetooth is not on, turn it on. The iPhone/iPad/iPod will
automatically search for new devices
a)
b)
Android Phones and Tablets
On your device, go to Settings menu
Select Wireless & Networks Bluetooth and if Bluetooth is not on, turn it
on. Select “Search for Devices” if your phone or tablet does not
automatically search for new devices
a)
b)
Computers and Laptops
Visit www.meelec.com/bluetooth for pairing, connecting, and audio device
setup for computers.
If pairing fails after several tries, please refer to your device’s user manual for
further information.