Mayline Pedestal Return - Manual (Page 3)

6. Align the holes in the two Joining Plates (E2) with the
pre-drilled holes in the underside of the Adjacent table
Work Surface. Attach each Joining Plate (E2) using four
Screws (E1).
7. Place the assembled Return in the upright position.
MAYLINE recommends that a minimum of two people
perform this task.
8. Lay the assembled Return onto the Joining Plates (E2).
Align the pre-drilled holes in the underside of the Return
with the slots in the Joining Plates (E2) and secure the
Return in place with four Screws (E1).
9. Level the assembly by adjusting all glides.
10. Return all drawers to the pedestal at this time.