beautypg.com

Mayline CSII Adjacent Peninsula User Manual

Page 2

background image

Peninsula Assembly:

NOTE: Size may vary but assembly procedure remains the same.

1. Place the Work Surface (1) face down onto a clean, protected surface.

2. Align the holes in the Post Leg (3) mounting plate with the pre-drilled holes in the Work Surface. Secure the

mounting plate with four screws (E1). Thread the Post Leg onto the mounting plate stud.

3. Align the holes in the two Connector Plates (2) with the pre-drilled holes in the underside of the Adjecent

Desk. Secure the Connector Plates using four Screws (E1) for each plate.

4. Place the adjacent desk at the location where it will be used. MAYLINE recommends that a minimumn of two

people perform this task.

5. Place the assembled Peninsula in the upright position. MAYLINE recommends that a minimumn of two
people perform this task.

6. Lay the assembled Peninsula onto the Connector Plates (2). Align pre-drilled holes in the underside of the

Peninsula with the holes in the two Connector Plates and secure the Plates using four screws (E1) for each
plate.

(2)