beautypg.com

Mayline CSII Freestanding Peninsula User Manual

Page 2

background image

Freestanding Peninsula Assembly:

NOTE: Size may vary but assembly procedure remains the same.

1. Place the Work Surface (1) face down onto a clean, protected surface.

2. Position Leg (2) approximately 3/16 from the edges and align the holes in the Leg with the pre-drilled holes in
the Work Surface. Attach Leg to Work Surface with seven Screws (E1).

3. Tighten all screws.

4. Install two Glides (E2) into Leg.

5. Align the holes in the Post Leg (3) mounting plate with the pre-drilled holes in the Work Surface. Secure the
assembled Post Leg using four screws (E1).

6. Place the assembled peninsula in the upright position. MAYLINE recommends that a minimumn of two

people perform this task.

7. Place the peninsula at the location where it will be used. MAYLINE recommends that a minimumn of two
people perform this task.

8. Level the assembly by adjusting the glides.

(2)