Mayline CSII Corner Desk - Manual (Page 2)

(2)
NOTE: Shape, size, and accessories may vary but assembly procedure remains the same. The legs included in
this assembly are similar in appearence. Identify the two legs with extra mounting holes prior to beginning the
assembly.
1. Place the Work Surface (1) face down onto a clean, protected surface.
2. Place Leg (3) in the corner of the Work Surface. NOTE: This is the Leg "without" the extra mounting holes.
Position this Leg approximately 3/16 from the edges and align the holes in the Leg with the pre-drilled holes in the
Work Surface. Attach the Leg with six Screws (E1). DO NOT tighten screws at this time.
3. Place Legs (4) at the edge of the Work Surface. Notice the position of the extra holes on the side of these Legs.
These holes will be used to join the Corner Desk to the adjacent tables. Position these Legs approximately 3/16
from the edges and align the holes in the Legs with the pre-drilled holes in the Work Surface. Attach each Leg with
six Screws (E1). DO NOT tighten screws at this time.
4. Attach the Modesty Panels (2) to each Leg with three Screws (E2) and three KEPS Nuts (E3) per end.
5. Tighten all screws at this time.
6. Install two Glides (E5) into each Leg.
7. Place the assembled Corner Desk in the upright position. MAYLINE recommends that a minimum of two people
perform this task.
8. Place the Corner Desk and the adjacent tables at the location where the final assembly will be used. MAYLINE
recommends that a minimum of two people perform these tasks.
9. Level the entire assembly by adjusting all of the glides.
10. Four Cable Clamps (E4) are included to position cables away from work area. Attach the clamps to the Work
Surface with one Screw (E1) per clamp.