Mayline SR4833 - Manual (Page 3)

5. Take the 6 pieces of double-faced tape and peel off the backing; then apply 2 to the bottom of
each outside end panel and 2 to the back panel.
6. With the assistance of another person, each lifting from an end panel, swing the end panels up
90 degrees from the back panels, and set the unit upright.
7. To install shelves, begin with the bottom shelf (1" front flange and no divider slots). Position the
shelf so its tabs (on side flanges only) lock into the bottom rows of loops on the inside end panels,
and its back flange is held by the tabs on the back panel, and set it gently into place. Repeat this
same procedure with the four shelves with slots in them.