Mayline TB60 Work Table & SLF60 Shelf - Manual (Page 3)

6. After deciding on table height, line up the threaded holes in each leg with the proper holes in the
leg sleeve; use two socket-head screws to assemble the leg in place (allen wrench provided)
7. Once all four legs have been assembled in place, carefully set table upright in place (be sure to
get help from another person).
8. Each leg has an adjustable glide. If the table needs to be leveled, turn the glide as needed to
shorten of lengthen any leg. While not essential, a carpenter's level may be helpful.
9. If you ordered the SLF60 Shelf, install it now as follows:
a. The shelf is made of (2) pieces (half shelves) which slide next to each other, flange side down.
The half - shelves are supported by the flanges at the bottom of the table end and back
panels.
b. Each half - shelf has one side with two notched corners; this side should be placed towards
the outside of the table (notches provide space for table legs).
c. Before installing the two half - shelves in place, check to make sure the two screws at the
bottom of the back of the table have been removed.
d. Carefully put the two half - shelves in place, first one, then the other. They should now be
next to each other, resting on the flanges at the bottom of the back and side panels.
e. Insert four painted machine screws. Each one will go through the hole at the bottom of the
table leg frame and the front corner of one of the half - shelves. Secure them with the
Kepsnuts provided.
f. Connect the two half - shelves from underneath through the bottom flanges using the three
painted machine screws and three Kepsnuts provided.
Table Height Max. 36"
Table Height Min. 29"
Table Height
Adjustment
Range 29" to 36" in
One Inch Increments