Longevity PROMTS 200 - Manual (Page 8)

ProMTS 200 200AMP Synergic MIG/TIG/STICK
- 8 -
Safety Tips
Consider the following tips to ensure safe operation of your welding/cutting
equipment:

Ensure that this welding equipment is installed in an area free of corrosive
chemical gases, flammable gases or materials, and explosive chemicals.

The area should contain little dust, and have a humidity of no more than 80%.

Operate the welding equipment in an area sheltered from direct sunlight and
precipitation. Work area temperature should be maintained at - to

If, because of an overload, the machine suddenly stops, and it is necessary to
restart it, leave the internal fan operating to lower the inside temperature.

Always wear protective clothing and a welding mask to protect your skin.

Wear safety goggles designed to darken the arc generated by your machine.

Wear suitable noise protection to protect your hearing.

Ensure that machine is grounded through the power cord or on the machine case.

Never operate the machine in bare feet or on a wet floor.
 Never switch the machine off while it’s in use. Doing so will damage the internal
circuitry.

Ensure that your circuit breaker is rated to handle the current requirements of
your machine.

Use a UL approved receptacles and plugs with your machine. Never hard wire
the machine to main power.

Work in a well-ventilated area to avoid smoke. Keep your head out of the smoke.
Ensure that air is flowing away from you to avoid inhaling smoke.

Ensure proper ventilation through the machine’s louvers. Maintain a distance
of at least 12 inches between this cutting equipment and any other objects in the
work area.

Use a screen or curtain designed to keep passer byes from viewing the arc.

The arc spray and metal spray from machine use may cause nearby fires. Use
caution.

If, after reviewing this manual, you have any problems in setting up or operating
your machine, contact us at [email protected].