Longevity FORCECUT 50D - Manual (Page 13)

ForceCut 40D and 50D plasma cutters
Page 12 of 30
www.longevity-inc.com
The LONGEVITY® 40D/50D Pilot Arc Plasma Cutters may or may not be dual voltage
varying by machine of purchase. Please check the back of your machine for the noted input
requirement or contact your LONGEVITY dealer for specifications.
Installation and Setup Instructions:
The item numbers referenced in the following paragraphs, refer to the numbered parts display in
the diagrams shown below. LONGEVITY® has an instructional setup installation video on our
website at www.longevity-inc.com , which we ask that you view prior installing the unit. The
video shows the complete assembly of the machine. The video is located in the Resources
section of the website under manuals and installation/set-up videos.
Connecting the electrical plug to the unit
Connecting the power plug to the unit is important. Please view the proper connection
instructions below:
Wiring Introduction for 220 Volt
Danger:
Read this manual completely before having your electrician attempt to wire up or
connect your machine to an electrical power source. LONGEVITY® units should be wired by a
certified electrician to insure your safety and a proper 110/220v plug match at your operating
facility. Remember 220v plugs come with 3 or 4 prongs on them. Have the electrician check
your existing receptacle.
Note:
The power cord on single-phase machines has one ground wire and two hot wires when
connecting to 220vac. Connecting these wires properly is extremely important. Improperly
connected wires will void the warranty, affect personnel safety, and possibly damage your
machine and electrical power outlet.