Longevity FORCECUT 42i - Manual (Page 11)

ForceCut 42i 110v/220v PFC 40amp Plasma Cutter
11
Installation
Unpacking
1. Inspect each item for possible shipping damage. If damage is evident, contact your distributor and / or shipping
company before proceeding with the installation.
Input Power Connections
Note: Check your power source for correct voltage before plugging in or connecting the unit
Gas Connections
A. Connecting Gas Supply to Unit
Connect the gas line to the inlet port of the gas filter on the rear panel.
B. Check Air Quality
To test the quality of air, put the RUN / SET switch in the SET (down) position, check if there are Any oil or moisture
in the air.