Breville EW40 - Manual (Page 5)

Before inserting
temperature control probe
into the Wok socket ensure
the interior of the socket is
fully dry. To do this, shake
out excess water then wipe
the interior of the socket
with a dry cloth.
3. Preheat the Avance Ultimate Wok on the
‘High Sear’ setting for approximately
10 minutes. The thermostat ‘On’ light will
illuminate on the heat control indicating
the temperature at which the dial is set.
4. When the thermostat light goes out this
indicates the wok has reached its set
temperature. The wok is now ready for
use. The thermostat light will cycle
on and off throughout cooking as the
temperature is maintained by
the thermostat.
5. When cooking is completed, turn
temperature control knob to the off
position (“0” on dial) before switching off
at the power outlet. Unplug from power
outlet. Leave temperature control probe
connected to the appliance until cool.
9 8
When stir fry cooking and a
high heat is required, set
temperature dial to ‘High
Sear’ and allow thermostat
light to cycle on and off
several times. This will
allow the cooking surface
to adjust to a more accurate
cooking temperature.
The Avance Ultimate Wok
must be used with the
temperature control probe
provided. Do not use any
other temperature control
probe or connector.
OPERATING YOUR BREVILLE WOK OPERATING YOUR BREVILLE WOK cont’d
NEVER OPERATE THE AVANCE ULTIMATE WOK WITHOUT THE BASE
POSITIONED DIRECTLY IN PLACE.
NEVER PLACE OIL OR FOOD INTO A COLD WOK WHILE IT IS HEATING,
THIS WILL GIVE A POOR COOKING RESULT.
THE AVANCE ULTIMATE WOK GETS VERY HOT DURING USE, ALLOW THE
UNIT TO COOL BEFORE MOVING OR STORING.
BEFORE FIRST USE
• • It is recommended you remove any
promotional labels and wash your Wok
and lid in hot soapy water. Rinse and
thoroughly dry.
• • The base is removable for easy cleaning
(see page 11).
• • Do not immerse the cord and/or
temperature control probe in water
or any other liquid.
OPERATING YOUR WOK
1. With the Push-Lever Removable Base
button in the ‘unlock’ position, place the
Avance Ultimate Wok into the outer
housing. Ensure the Wok is firmly located
on the base tray then move the
Push-Lever button to the ‘lock’ position.
2. Insert the Temperature Control Probe
into the socket at the side of the Avance
Ultimate Wok. Plug into a 230/240v power
outlet and switch ‘on’. Always insert the
heat controller into the appliance first,
then plug into main power outlet.
BR4902 EW40 Avance Wok Book.qxd 14/1/04 11:59 AM Page 8