BOXLIGHT MP-38t - Manual (Page 29)

29
BASIC OPERATION
Press the FREEZE button on the remote control unit to freeze the picture on screen. This function is cancelled when the
FREEZE button is pressed again or any other button is pressed.
NOTE: Your computer or video equipment is not affected by this function, and will continue to run.
NO SHOW FUNCTION
NORMAL PICTURE FUNCTION
FREEZE PICTURE FUNCTION
AUTO IMAGE FUNCTION
Press the NO SHOW button on the remote control unit. The screen will change into
black image and the "NO SHOW" is displayed on the screen for a few seconds.
This function is cancelled when the NO SHOW button is pressed again or any other
function button is pressed.
Press the AUTO IMAGE button on the remote control unit or on the projector. The item(s) indicated "ON" in the AUTO
IMAGE FUNCTION are adjusted automatically.
If all the items in AUTO IMAGE FUNCTION are "OFF", AUTO IMAGE SETTING display appears. If you wish to operate
the AUTO IMAGE FUNCTION, perform the steps 3 - 9 of "AUTO IMAGE FUNCTION" section on page 38.
The normal picture image level is factory preset on the projector and can be
restored anytime by pressing the NORMAL button on the remote control unit or on
the projector. The "Normal" display will be displayed on the screen for a few
seconds.
P-TIMER FUNCTION
Press the P-TIMER button on the remote control unit. The timer display "00:00" appears on
the screen and the timer starts to count the time (00:00 to 59:59).
Press again the P-TIMER button to stop the timer. Then press the P-TIMER button to
cancel the P-TIMER function.