Labnet Mini LabRoller Dual Format Rotator User Manual
Page 2
1
1.0 GENERAL SPECIFICATIONS
Electrical requirements:
115 volt model
115V ±10% 50/60Hz, 0.03A
230 Volt model
230V ± 10% 50/60Hz, 0.015A
Speed:
115 volt model
24 rpm
230 Volt model
20 rpm
Motion
Rotating
Maximum Capacity
H5500-02
36
x
1.5ml or 2.0 ml tubes
H5500-15
10
x
15ml
tubes
12
x
5/7ml
tubes
H5500-50
6
x
50
ml
tubes
Dimensions WxLxH
21.3 X 10.2 X 12.6 cm
Included accessories
Rotisserie 36 x 1.5ml or 2.0 ml tubes
(H5500-02)
Weight
0.8 kg
Operating conditions
4ºC to 65ºC, up to 85% RH, non-
condensing
2.0 INSTALLATION OF THE ROTATOR
2.1
UNPACKING
Before starting the installation, carefully examine the rotator:
Open the box and carefully remove the padding. Check to see that
the rotator has not been damaged during transportation. Keep the
packing material until you are sure the rotator works properly.
Make sure that all of the accessories are included.
Carefully lift the unit from the box.
Be sure that the following information is included on the serial number
located on the bottom of the unit: Serial number, Product number,
Electrical
rating.
Check that the power cord has the correct configuration that matches
the outlet according to your local standards.
If any damage occurred during transportation, contact your carrier
immediately.
2.2 STARTING UP THE ROTATOR
Place the rotator on a level and stable surface. Connect the plug into a
grounded outlet. Avoid lines where line surges may occur, i.e.
refrigerators and similar devices are connected, Use the on/off switch to
control
the
rotator.