Labnet AccuPlate Hotplates, Stirrers and Hotplate Stirrers - Manual (Page 5)

5
Product Connections
1. Power Cord Input: Connect the supplied power cord into this connector.
2. External Temperature Controller Input: Connect the optional External Temperature
Controller into this connector.
To Connect the External Temperature Controller
1. Turn the Stir Control Knob and Heat Control Knob to the OFF position.
2. Disconnect power cord.
3. Insert temperature controller connector into the input connector.
4. Reconnect power cord.
5. Product is now ready for use with External Temperature Controller.
Repeat the above process when disconnecting the temperature controller.
Stirring Instructions
D0410, D0420
1. Fill vessel with solution to be stirred.
2. Place stir bar into vessel.
3. Place vessel in the center of the top surface.
4. Turn Stir Control Knob until the Stirring Speed Display shows the desired speed. The
speed setting can be adjusted according to the table below.
Operating Range
(RPM) Adjustable
Increment, (RPM)
60-100 5
100-200 10
200-400 20
400-1150 50
Flashing Display: The number will FLASH when actual stirring speed is not at set speed.
Constant Display: The number will not flash when actual stirring speed is at the set
speed. The number will remain constantly ON when the actual stirring speed is at the set
speed.
1 2