Kisan Electronics PH4 - Manual (Page 4)

PH4 INSTALLATION:
n
Gain access to the
back of the headlight bulb
– you may have to open
up the headlight bucket or
peel back any rubber
protective boot.
o
Unplug the 3-pin
socket and unhook the
spring clip that holds the
bulb in place. Then pivot it
out of the way so that the
bulb can be removed.
p
Insert PH4 pathBlazer so that the (3) tabs of the bulb-mounting base
are lined-up and spring clip clears the Daylight Sensor cable.
q
Now hook the spring clip back to secure the bulb and plug in the 3-pin
socket
Note! If you have the older twist-lock style retainer instead of the spring-
clip, be sure to feed the Daylight Sensor thru’ the retainer opening.
Daylight Sensor is not detachable on this unit, so after installing the PH4
pathBlazer route the cable to a suitable location to mount the photo-eye
of the sensor such that it faces the sky.