Kasco 750 Seeder - Manual (Page 2)

MODEL 750
S PINNING BLADES HAZARD
To Prevent Serious Personal Injury or Death
Warning Decal -
If missing
Call 574/753-6311
for free
replacement.
CAUTION: KEEP all guards and shields in place at all times. Disengage power take-off and shut off tractor
engine before making any adjustments or repairs to seeder. KEEP hands, fingers and loose clothing well away from
any and all moving parts at all times.
PARTS FOR MODEL 750 BROADCASTER SHOWN IN PHOTO: (750 LB., 9.6 BU., OR 12 CU. FT. CAPACITY)
(WHEN ORDERING PARTS, BE SURE TO GIVE BOTH MODEL NUMBER AND SERIAL NUMBER. SEE TOP OF PAGE FOR LOCATION OF
SERIAL AND MODEL NUMBERS.)
PART NO.
NO. NO. NAME REQ.
1. 1091 WARNING SPINNING BLADES DECAL ....................................................................................................... 1
2. 102 BLADES FOR FAN, WITH BOLTS (420) ....................................................................................................... 4
3. 106 SEED GATE GUIDES ..................................................................................................................................... 2
4. 107 1/4" x 1/2" CAP SCREWS - TO HOLD CONTROL PLATE TO BASE PLATE ............................................. 4
5. 111 5/16" x 2" SPRING PIN, FOR DRIVEN END OF POWER TAKE-OFF SHAFT AND FAN.......................... 2
6. 78 REPAIR KIT "W" FOR P.T.O. SHAFT (PIN & BLOCK TYPE) FOR WEASLER P.T.O.................................. 2
843 CROSS & BEARING REPAIR KIT (G & G P.T.O. SHAFT)............................................................................ 2
79P NYLON BEARING FOR PLASTIC SHIELD OF WEASLER P.T.O. SHAFT ................................................. 2
46 BEARING SHIELD KIT, NYLON BEARING, SNAP RING & THRUST WASHER - FOR G & G ................ 2
80P BEARING RETAINER FOR PLASTIC SHIELD OF WEASLER P.T.O. SHAFT............................................ 2
7. 116 TENSION SPRING ......................................................................................................................................... 1
8. 117 EYE-BOLT ....................................................................................................................................................... 1
9. 407 5/16" x 1" BOLT W/NUT & LOCK WASHER.................................................................................................. 1
10. 213 BRACKET FOR CONTROL HANDLE, UPPER & LOWER .......................................................................... 2
12. 144 HOPPER BASE PLATE .................................................................................................................................. 1
13. 145 FAN BASE ONLY (TO WHICH BLADES FASTEN)....................................................................................... 1
!
Page 1
• KEEP HANDS, FEET AND CLOTH-
ING AWAY FROM SPINNING
BLADES.
• STAY CLEAR OF ALL MOVING
PARTS WHEN IN OPERATION.
KEEP OTHERS AWAY.
• KEEP ALL GUARDS IN PLACE.
STOP MACHINE AND DISCON-
NECT POWER BEFORE ADJUST-
ING, LUBE OR SERVICE.
SERIAL NUMBER
LOCATED ON
WELDED PLATE,
JUST BELOW
MODEL NO.
DECAL