Bosch 3924B - Manual (Page 5)

5
“SAVE THESE INSTRUCTIONS”
THE WARNINGS SHOWN BELOW CAN BE FOUND ON YOUR TOOL. THESE WARNINGS ARE ONLY A
CONDENSED FORM OF THE MORE DETAILED SAFETY RULES AND PRECAUTIONS THAT APPEAR IN
YOUR OWNER'S MANUAL. THEY SERVE AS A REMINDER OF ALL SAFETY RULES NEEDED FOR SAFE OPERATION OF
THIS MITER SAW.
Safety
“READ ALL INSTRUCTIONS” — Failure to follow the SAFETY RULES identified by BULLET (•) symbol listed
BELOW and other safety precautions, may result in serious personal injury.
After turnin
g saw "OFF", always keep saw in
down
posi
tion
and
wait fo
r blade
to stop befo
re removing cutoff pieces, cleaning
table,
or ch
angi
ng tool s
ettings
. • Exten
d the sliding base when making bevel or co mpou
nd c
uts
or
table
is turn
ed to th
e left side
to avoid contact with guard system
. • Cl
amp
work
-
piece
again
st the
base or fe
nce. Never perform any operation freeh and.
Do not ope
rate saw without guards in place
and o
pera
ting
.
If gua
rd fails
to operate
smoothly, stop sawing and service
it befo
re pr
ocee
ding
.
• Retu
rn guard
to operating
position after changing the b
lade. •
Neve
r pla
ce y
our
hand
across
the projecte
d path of the saw blade. • Do not
reach
behin
d, b
ene
ath
or
in fron
t of the
blade. Keep
hands at a safe distance from
the sa
w bla
de.
To reduce the risk of
injury, user must read and under-
stand the instruction manual.
• Wear eye protection and dust
mask. • Use 10 inch diameter
saw blade rated at 4300 rpm or
greater. • Remove battery pack
before servicing or changing
blade. • Use with BAT030 battery.
3924 10"(254MM) CORDLESS
COMPOUND MITER SAW
SN:
511
LISTED
37J2
S-B Power Tool Co. Chicago, IL.
Made in
Taiwan
24V n o 3600/min 0 601 663 439
® C US
E82443
DESIGNATED DANGER ZONE.
AVOID POSITIONING HANDS,
FINGERS OR ARMS IN THE
AREA DESIGNATED BY THIS
SYMBOL.
WARNING !
WARNING !