Jabra LINK 280 - Manual (Page 5)

5
how To adJusT voLume on The conTroLLer
Use the wheel at the center of the
controller to adjust the volume.
Turn clockwise to turn up and
counterclockwise to turn down. You will
hear a soft click in the headset each time
you adjust the volume.
When you reach maximum volume, the
headset will beep twice as a warning.
We recommend that you do not use the
headset at full volume.
* See www.jabra.com for an up-to-date list of supported softphones.
how To muTe The headseT
Tap the mute button on the USB controller to mute the headset microphone. The mute light on the USB control-
ler will change from green to red.
To un-mute the headset microphone, tap the mute button again, and the mute light will change from red to
green.
Green when not muted
Red when muted
how To answer a caLL from your Pc sofTPhone
When a softphone call arrives, you will hear a ring tone in the headset. If you are using a Jabra-supported
softphone*, then answer by tapping on the hook-switch button on the USB controller; tap again to hang up
when you are done. Softphone control requires that you install Jabra PC Suite (described later in this manual).
For other softphones, use the native interface on your computer to answer and hang up.
Green when idle
Flashing green/
when incoming
call
Red when on a call
Function Answer/end button
Answer or end a call Tap
Reject incoming call Press and hold (1 sec)
Put current call on hold Press and hold (1 sec) during call