Bissell QuickSteamer 1950 series - Manual (Page 6)

6
Vacuum carpet thoroughly.
Decide where to begin — and end — your job. Clean in 3’ X 4’
sections, starting in areas farthest from exit. Plan to leave a path
open to empty soiled water and refill cleaner.
Carpeting will dry in three to four hours, depending on
carpet style and air circulation in room. A floor fan
speeds drying.
Replace furniture on damp carpeting by placing waxed
paper under legs until floor dries completely.
Remove the Clean Water Tank by lifting it straight up,
then away from the Lower Body.
Using the Formula Measuring Cap, add two (2) capfuls of
BISSELL
® Advanced Cleaning Formulas for Deep Clean-
ing Machines to the Clean Water Tank. Add 1/2-gallon of
hot (NOT boiling) tap water. Fill only to fill line – do not
overfill.
Replace and turn Formula Measuring Cap clockwise
until secure.
Place Clean Water Tank on Lower Body.
Rotate Quick Release Cord Wrap and plug in.
Turn Power Switch [located on the back of the Lower
Body] to ( ) ON.
If cleaner starts when first plugged in, switch cleaner
OFF ( ) until ready for use.
Pre-treat stubborn stains and highly soiled carpet in hallways and
other high-traffic areas.
Spray soiled area with BISSELL ® Tough Stain PreCleaner. ™
Use a stiff-bristled brush to work formula into carpet pile.
Wait 3 -5 minutes before deep cleaning.
How to begin - Continued
3.
4.
5.
Getting ready
1.
2.
6.
3.
4.
5.
6.
7.
Tip:
Always vacuum
thoroughly before
you deep clean.
If possible, move
larger furniture to
an area you will
not be cleaning.
Formula
Measuring
Cap
Unscrew to Remove
Power
Switch
1.
6.
Pre-Treating
1.
2.
3.
Tip:
Deep cleaning
spots, spills
and high traffic
areas on a
regular basis can
prolong
carpet life.