Specifications, Set-up instructions – HMC Electronics DT1 Kolver Dual Torque Optical Switch User Manual
Page 2
SPECIFICATIONS
Model DUAL-torque: DT1
SET-UP INSTRUCTIONS
1.00
3.900
R .500
5.50
1.625
Front View
2.400
.050
Two holes Drill letter N
Through to inside pocket
run at same angle as this
surface.
Ø
Weight:
2.5 lbs
Power:
None required - the unit is powered off the connection to
the KolverEDU1AE/C controller
Lights:
Blue and white high power LED
Switch:
Non-wearing optical sensors
Cable Length: 7.5 ft standard; optional lengths available upon request
Step One:
Plug the connector end of the cable supplied
with the Model DUAL-torque: DT1 into the
connector on the back of the Kolver model
EDU1AE/C controller.
Step Two:
Adjust and calibrate the first torque setting on
the front digital display as normally done.
Step Three:
Swipe your finger through the optical sensor
channel of the DT1
Step Four:
Adjust the second torque setting by turning
the trim-pot on the back of the controller. The
digital torque value will change on the front
display accordingly. Calibrate as required.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440