Hawke Optics Nite-Eye Digital 4-16x50 10X ½ Mil Dot - Manual (Page 2)

Down
Up
Digital Operation Digital Operation
®
• At any stage of brightness you
can switch between colours by
pressing the button for 2
seconds.
• To switch off the illumination hold
down both buttons simultaneously
for 2 seconds then release.
• When the battery becomes
exhausted the reticle illumination
will flash momentarily approx
every 10 seconds. It’s now time to
change the battery.
• Always remove the battery if the
scope is out of use for a prolonged
period.
• The illumination controls are
positioned on the top of the
eyebell. The battery is located
under the round cover.
• The button is on the right. This
increases the brightness
• The button is on the left. This
decreases the brightness
www.hawkeoptics.com
Controls Digital Illumination
The Nite-Eye Digi IR SF has the
following exclusive features:
• Switchable from red to blue
illumination
• 24 levels of illumination
• Auto switch off after approx 1hour
if not used
• Low battery level indicator
• Low profile design
• Longer battery life
Features
Extreme shooting conditions demand
a high performance reticle illumination
system.
When its dawn or dusk too much
reticle brightness is undesirable as it
limits the shooters natural vision.
Hawke have designed a state of the
art 24 level illumination system which
is fully controllable step by step from
an extremely low
brightness level suitable when it’s
almost dark to a high brightness level
for use in sunlight.
There are two colour settings-
Blue for daytime
Red for dawn and dusk
• The battery is a CR2032 lithium
button cell. Insert the + of the
battery uppermost.
• To switch on the illumination
momentarily press the button
• The button if held down for 2
seconds will change the
illumination from red to blue and
after releasing the button if held
down again for 2 seconds the
illumination changes back to red.
• To alter the brightness level the
buttons can be momentarily
pressed for less than 1 second,
each press steps the illumination
1 level, button increases and
button decreases the brightness.
+
+
+
+
-
-
-
-