Gardman Butterfly flexi border Lights - Manual (Page 2)

Assembly:
n Remove the parts carefully from the packaging to avoid
tangling wires.
n Connect the solar panel to the ground spike.
n Locate the solar panel connector on the end of the flexi stem
cord and push it firmly into the socket on the back of the solar
panel.
n Move the switch to the ‘on’ position.
Installation:
n Maximum sunlight will give the internal battery the best
charge and so give best results.
n Position solar lights where they are free from cover or shade
and, ideally, in a position that receives full sun throughout the
day.
n Avoid other light sources which may cause solar lights to flicker
on and off. Also allow a space of approx. 1.5m (5ft) between
solar lights.
n Push the lower stem section carefully into the ground: if the
ground is hard, first make a hole to avoid damaging the stem.
n When the lower stem is in the desired position, add the top
section (push fit) and the crystal figure.
n Solar lights will not be very bright or long lasting until a full
day’s sunlight has been received.
n Alternatively, batteries can be charged to full capacity in a bat-
tery charger before use.
Maintenance:
n If solar panel gets dirty, the charging capacity will be reduced.
Clean panels occasionally with a damp cloth - avoid harsh
detergents or solvents as these can damage the panel.
n Batteries can be given a temporary boost in a battery charger
if there has been limited sun or extra light is needed for a
special occasion.
n Batteries may need replacing after 1-2 years, depending on the
conditions they have had to endure. The batteries are housed on
the underside of the solar panel and can be easily accessed by
unscrewing the 2 screws.
n The battery (1xAA) can be replaced with any 1.2v rechargeable
ones available in retail outlets: choose a low power output (mAh).
Gardman replacement batteries are ideal for the purpose
n Low winter light levels or harsh weather in your locality may lead
you to decide to store your solar lights indoors until conditions
improve. If so, clean and dry the lights, turn off or remove the
batteries: store in a dry spot and reassemble in spring as de-
scribed in ‘installation’.
Troubleshooting:
If your solar light does not operate properly at night it may be
caused by one of the following:
n Ensure the switch, if present, is in the on position and any battery
tabs removed.
n Low light levels caused by the position of the light, lack of sun or
short daylight hours will shorten the light duration.
n Other lighting can cause flickering in a solar light or even prevent
it operating.
n Check the batteries in case they need replacing:
see ‘maintenance’ above.
In the event of your Solar Light failing, please turn the
operating switch off and leave to fully charge for 2 - 3
days in direct sunlight. After this time turn the switch
back to the ‘on’ position for working operation. If the
operation failure continues to persist, please contact
our Customer Service department.
3 2