Gardman Dragonfly Glowlight - Manual (Page 2)

Assembly:
n Remove the battery isolation tab from the top section,
beneath the solar panel.
n Do not add the top to the stem section at this stage or damage
may occur when positioning – see ‘installation’ below.
n Remove the spike cover before fixing this section in the ground.
n Carefully fit the crystal figure over the LED when the
complete stem is in place.
Installation:
n Maximum sunlight will give the internal battery the best
charge and so give best results.
n Position solar lights where they are free from cover or shade and,
ideally, in a position that receives full sun throughout the day.
n Avoid other light sources which may cause solar lights to flicker
on and off. Also allow a space of approx. 1.5m (5ft) between
solar lights.
n Push the lower stem section carefully into the ground: if the
ground is hard, first make a hole to avoid damaging the stem.
n When the lower stem is in the desired position, add the top
section (push fit) and the crystal figure.
n Solar lights will not be very bright or long lasting until a full day’s
sunlight has been received.
n Alternatively, batteries can be charged to full capacity in a bat-
tery charger before use.
Maintenance:
n If solar panels get dirty, the charging capacity will be reduced.
Clean panels occasionally with a damp cloth – avoid harsh deter-
gents or solvents as these can damage the panel.
n Batteries can be given a temporary boost in a battery charger if
there has been limited sun or extra light is needed for a special oc-
casion.
n Batteries may need replacing after 1-2 years, depending on the
conditions they have had to endure. The battery is housed under
the solar panel and can be easily
accessed by removing the battery cover.
n The battery (1 x AA) can be replaced with any 1.2v
rechargeable ones available in retail outlets: choose a low power
output (mAh). Gardman replacement batteries are ideal for the
purpose.
n Low winter light levels or harsh weather in your locality may lead
you to decide to store your solar lights indoors until conditions
improve. If so, clean and dry the lights, turn off or remove the bat-
teries: store in a dry spot and reassemble in spring as described in
‘installation’.
Troubleshooting:
If your solar light does not operate properly at night it may be caused
by one of the following:
n Ensure the switch, if present, is in the on position and any battery
tabs removed.
n Low light levels caused by the position of the light, lack of sun or
short daylight hours will shorten the light duration.
n Other lighting can cause flickering in a solar light or even prevent it
operating.
n Check the batteries in case they need replacing:
see ‘maintenance’ above.