Gardman 10 Flare Solar Lights - Manual (Page 2)

Assembly:
n Push the solar panel onto the stem and then push the spike into
the bottom of the stem.
n Move the switch to ‘on’.
Installation:
n Maximum sunlight will give the internal battery
the best charge and so give best results.
n Position solar lights where they are free from cover or shade and,
ideally, in a position that receives full sun throughout the day.
n Avoid other light sources which may cause solar lights to flicker
on and off. Also allow a space of approx. 1.5m (5ft) between
solar lights.
n Push the spike carefully into the ground: if the ground is hard,
first make a hole to avoid damaging it.
n Solar lights will not be very bright or long lasting until a full day’s
sunlight has been received.
n Alternatively, batteries can be charged to full capacity in a
battery charger before use.
Maintenance:
n If solar panels get dirty, the charging capacity will be reduced.
Clean panels occasionally with a damp cloth – avoid harsh
detergents or solvents as these can damage the panel.
n Batteries can be given a temporary boost in a battery charger if
there has been limited sun or extra light is needed for a special
occasion.
n Batteries may need replacing after 1-2 years, depending
on the conditions they have had to endure. The batteries are
housed at the reverse of the solar panel and can be accessed by
removing the panel.
n The battery (1 x AA per light) can be replaced with any 1.2v
rechargeable ones available in retail outlets: choose a low
power output (mAh). Gardman replacement batteries are
ideal for the purpose.
n Low winter light levels or harsh weather in your locality may
lead you to decide to store your solar lights indoors until
conditions improve. If so, clean and dry the lights, turn off or
remove the batteries: store in a dry spot and reassemble in
spring as described in ‘installation’.
Troubleshooting:
If your solar light does not operate properly at night it may be
caused by one of the following:
n Ensure the switch, if present, is in the on position and any
battery tabs removed.
n Low light levels caused by the position of the light, lack of sun
or short daylight hours will shorten the light duration.
n Other lighting can cause flickering in a solar light or even
prevent it operating.
n Check the batteries in case they need replacing: see
‘maintenance’ above.