Gardman SS Post Lights - Manual (Page 2)

Assembly:
n Push the stem into the light assembly.
n Remove the top section of the light and move the switch to ‘on’.
Installation:
n Maximum sunlight will give the internal battery the best charge
and so give best results.
n Position solar lights where they are free from cover or shade
and, ideally, in a position that receives full sun throughout
the day.
n Avoid other light sources which may cause solar lights to flicker
on and off. Also allow a space of approx. 1.5m (5ft) between
solar lights.
n Push the spike carefully into the ground: if the ground is hard,
first make a hole to avoid damaging it.
n Solar lights will not be very bright or long lasting until a full
day’s sunlight has been received.
n Alternatively, batteries can be charged to full capacity in a
battery charger before use.
Maintenance:
n If solar panels get dirty, the charging capacity will be reduced.
Clean panels occasionally with a damp cloth – avoid harsh
detergents or solvents as these can damage the panel.
n Batteries can be given a temporary boost in a battery charger if
there has been limited sun or extra light is needed for a
special occasion.
n Batteries may need replacing after 1-2 years, depending
on the conditions they have had to endure. The batteries are
housed on the underside of the solar panel of the light and
can be easily accessed by removing the panel. The batteries
are housed under the head of the light and can easily
accessed by removing the top section of the light and lifting
the cover.
n The battery (1 x AA per light) can be replaced with any 1.2v
rechargeable ones available in retail outlets: choose a low
power output (mAh). Gardman replacement batteries are
ideal for the purpose.
n Low winter light levels or harsh weather in your locality
may lead you to decide to store your solar lights indoors
until conditions improve. If so, clean and dry the lights,
turn off or remove the batteries: store in a dry spot and
reassemble in spring as described in ‘installation’.
Troubleshooting:
If your solar light does not operate properly at night it may be
caused by one of the following:
n Ensure the switch, if present, is in the on position and any
battery tabs removed.
n Low light levels caused by the position of the light, lack of
sun or short daylight hours will shorten the light duration.
n Other lighting can cause flickering in a solar light or even
prevent it operating.
n Check the batteries in case they need replacing: see
‘maintenance’ above.