Gardman Sun Jar - Manual (Page 2)

Assembly:
n Remove the sun jar carefully from the packaging.
n Lift up the lid and move the switch, located on the solar
panel inside the jar to ‘on’ to activate.
n Replace the lid on the sun jar.
Installation:
n Maximum sunlight will give the internal battery
the best charge and so give best results.
n Position solar lights where they are free from cover or
shade and, ideally, in a position that receives full sun
throughout the day.
n Avoid other light sources which may cause solar lights
to flicker on and off. Also allow a space of approx. 1.5m
(5ft) between solar lights.
n The light is perfect for table-top use but can be used on
any flat surface.
n Solar lights will not be very bright or long lasting until
a full day’s sunlight has been received.
n Alternatively, batteries can be charged to full capacity in a
battery charger before use.
Maintenance:
n If solar panels get dirty, the charging capacity will be
reduced. Clean panels occasionally with a damp cloth
– avoid harsh detergents or solvents as these can damage
the panel.
n Batteries can be given a temporary boost in a battery
charger if there has been limited sun or extra light is
needed for a special occasion.
n Batteries may need replacing after 1-2 years, depending
on the conditions they have had to endure. The battery
is housed on the reverse of the solar panel.
n The battery (1 x AA) can be replaced with any 1.2v
rechargeable ones available in retail outlets: choose
a low power output (mAh). Gardman replacement
batteries are ideal for the purpose.
n Low winter light levels or harsh weather in your locality
may lead you to decide to store your solar lights indoors
until conditions improve. If so, clean and dry the lights,
turn off or remove the batteries: store in a dry spot
and reassemble in spring as described in ‘installation’.
Troubleshooting:
If your solar light does not operate properly at night it may
be caused by one of the following:
n Ensure the switch, if present, is in the on position and
any battery tabs removed.
n Low light levels caused by the position of the light, lack
of sun or short daylight hours will shorten the
light duration.
n Other lighting can cause flickering in a solar light or
even prevent it operating.
n Check the batteries in case they need replacing: see
‘maintenance’ above.